Polishing machine manipulation

Source：未知 Click：112 Date：2017-09-15 09:14:27【L M S】

I. layout:

Machine handle, chassis, motor, wire, electronic switch.

Two. Pace:

1. polishing machine is held up wax, polishing on the marble floor. To increase the brightness of the ground, the machine needs more than 1000 revolutions per minute or more, using liquid high-speed polishing wax.

2. check whether the machine body is normal, whether the wax pot nozzle is blocked or not.

3. will be high-speed polishing of the ground clean and clean.

4. place the white high speed polishing pad.

5. switch on the power and adjust the handle to its proper position.

6., when polishing should be slightly raised the head, until the normal speed, and then lower the head.

7., polishing pad spray in the situation, spray wax to fog, "upper and lower 30CM, horizontal distance 80-100CM".

8. after polishing, you should clean the floor with dust, and clean the pad and the machine in real time. 9. clean everything according to the regulations and place them properly.

Three, meticulous work:

1., usually nursed back to health, often clean and rigid, regularly check the power supply, regular oiling. 2., put a warning card in order to remind guests or others carefully. 3. in operation, the power cord should be placed on the shoulder to prevent the line from falling under the mobilization disk, so as not to cause accidents.