How does a pneumatic polisher polish the glass?
Glass polishing is a very fine grinding skills, requiring our operators to work carefully and carefully, and today we introduce the use of pneumatic polishing machine to polish the common sense of glass.
After the end of glass grinding, then polishing in the workpiece, can make glass into appearance when lit, polishing, and polishing powder glass appearance demand, polishing and grinding grinding machine is the use of the same, so the grinding process and rules are all adjustable correct use and polishing.
After grinding the workpiece end, need to use warm water wash, in order to effectively eradicate the adhesion of diamond powder, and then the workpiece with pneumatic polishing machine for polishing, polishing and necessary concave glass surface shape with uniform friction can immediately glass mirror bright.
Usually, warm water is prepared at the side. The disc is dipped in a temperature bucket to soften the surface, and then placed on the workpiece to fit with the glass and then start the grinding machine.
Polishing is necessary for grinding workpiece shape, appearance and other processing scene photometric exactly, polished to 5 minutes will demand processing, stop check, look at the photometric center marginal range is not the same, in order to determine the polishing process is not accurate, polishing in the workpiece, can not add too much polishing powder, or the polishing agent plays the role of sliding, but no polishing, polishing agent can use the automatic machine device increases, the amount of required polishing with inspection are defined, due to the polishing workpiece surface degree is not the same, is able to conclude that the Polish variety is not used correctly.
Polishing process will not affect the final thickness of the workpiece, the normal polishing process at most will be the workpiece inspection to reduce the thickness of 0.03mm, and this value is in the scale permitted by the public service.
After the polishing time more than half, and then inspect the workpiece, the public service is to meet the requirements of the scale, this check contact is very large, if it is not required to do the polishing requirement timely correcting, after polishing the correction is very serious and correcting disc criterion.
When the workpiece surface processing, the inspection glass appearance is not meet the requirements, the best is examined in the light, and then the workpieces were clean, finally the glass will be coated with protective rubber for glass lens maintenance.
Recommend
Industry News
- What is the key to polishing ma
- Use and maintenance of pneumati
- Safe operation process of polis
- Polishing machine manipulation
- Polishing machine construction
- How does a pneumatic polisher p
- The use of cylindrical polishin
- Polishing machine introduction
- How to repair and protect magne
- What are the features and featu